RAPID® T-Lift serves as a transport system, for example, prefabricated roofs, wall or ceiling elements, cross laminated timber or solid wood panels. The system consists of the RAPID® T-Lift screw and the RAPID® T-Lift hoist . RAPID® T-Lift screw is available in diameters 12x120/100 mm, 12x160/144 mm. Further diameters on request.
Use in building timber construction as lifting system for prefabricated roofs, wall and ceiling elements, timber panel construction for the prefabricated house sector, solid wood panels such as laminated panels etc.
RAPID® T-Lift is suitable for plywood, solid timber, timber materials (OSB, LVL, etc.) and softwood. In hardwood, we recommend using the screw with a pre-drilled pilot hole.
Suitable for axis loads (screw subjected to tension) and for transverse loads (screw subjected to shearing).
Application notes
The lifting system corresponds to the load group up to 1.3 tonnes and is only tested in connections with Ø 12 mm screws according to ETA-12/0373 with a dual head.
The weight of the components to be lifted must be known and must not exceed the calculated screw bearing force.
Screws must not be screwed into drying cracks or similar defects.
Screw-in angle in the timber: 0 - 90°
Saftey instructions
For safety reasons, the screws must only be used once.
The entire component must be lifted with at least two screws.
Check the RAPID® T-Lift for damage before each use.
At least 1x / year the lifting system has to be checked by an expert / safety officer of the user company. Apart from damage of all kinds, the degree of wear and tear in particular should be determined.
Modifications and repairs, especially welds on the lifting system are not permitted!
Available diameters
The RAPID T-Lift is available at the following diameters:
12x60 mm* 12x80 mm* 12x120 mm 12x140 mm* 12x160 mm 12x180 mm* 12x220 mm*